Learn how to use 100Ah and 300Ah Advanced Lithium Batteries with our guide.
To prevent a surge current, perform a “pre-discharge” as outlined in the
steps below.
Step 1 - Ensure all batteries are in Power Off mode.
Step 2 - Connect batteries following the series or parallel connection diagrams found at gopowersolar.com/advanced-lithium-wiring. When stacking multiple batteries, a communication cable is required between each battery. A Terminating Resistor on the last battery is also required on each end of the battery bank. (If the installation utilizes a screen, the terminating resistor is not required on one end.)
Step 3 - Ensure battery pack terminals are correctly installed and connected to
the inverter system.
Step 4 - Press the power button on one of the battery packs for 3 seconds to
wake up all battery packs from Power Off mode. The LED indicator
will turn on
Note: Batteries are in Power Off mode when unboxed. Press the Power button
for 3 seconds to turn on. If it doesn’t turn on, you will need to charge
the battery.
The batteries need to be configured before they can be used. Please see
battery manual for instructions on battery configuration.