You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
Home > Inverter Support > Pure Sine Wave Inverter Support > ISW Inverter Support (700 to 4000 watts) > ISW Inverter 700-4000: Installation & Mounting Requirements
ISW Inverter 700-4000: Installation & Mounting Requirements
print icon

Typical System Overview


The following diagrams show how the GP-ISW-Inverter and GP-ISW-R are typically installed in a mobile RV application. The diagrams show where the remote and Inverter are installed and how the mobile power system can be integrated with a Go Power! RV Solar Kit (sold separately by Go Power, please contact us directly.)






Mounting Requirementss



Make sure the GP-ISW is installed in a location where the normal air temperature is between -20°C and 40°C. The cooler the better within this range.



Do not allow water or other fluids to come into contact with the GP-ISW. Do not expose to rain, snow or water.



For optimum Inverter performance the GP-ISW must be installed so the front and rear air vents are not blocked or obstructed in any way. Do not install the GP-ISW in an area with limited air flow. Allow as much space around the Inverter as possible, leaving at least 4 inches of airspace clearance around all ventilation areas. CAUTION! Equipment Damage. Do not mount the GP-ISW in a zero clearance compartment. Do not cover the ventilation openings. Overheating and mechanical failure may occur.



Install the GP-ISW away from the battery bank, away from any flammable or combustible material (paper, flammable liquids, gasoline, cloths) that may be ignited by heat, sparks or flames. Never place the Inverter directly above the battery bank - gases from the batteries will corrode and damage the Inverter, never allow battery acid to drip onto the unit.



Do not block access to the GP-ISW remote control access port, status LEDs and the On/Off switch. Allow enough room to access the AC and DC wiring terminals and connections as they will need to be checked and tightened periodically. The GP-ISW must be installed in one of the approved mounting orientations detailed on page 20. DO NOT MOUNT VERTICALLY.



The GP-ISW should be installed in a location which is clean and limits the introduction of dust, fumes, insects or rodents which could enter and block the Inverter ventilation openings.



The GP-ISW should be located as close to the batteries as possible but not within the same compartment. The length and size of the DC Cables will affect performance. Long DC wires tend to lose efficiency and reduce the overall performance of the Inverter/Charger.




Products covered in this article: GP-ISW-700, GP-ISW-1000, GP-ISW-1500, GP-ISW-2000, GP-ISW-3000, GP-ISW-4000

1 out of 5 found this helpful

scroll to top icon