Eliminating Timing delay of Transfer Switch

In order to eliminate the delay on a transfer switch position j1 on the timing board will have to be shorted together.  This can be done by soldering a jumper across the board or adding a shunt jumper to the header.

The jumper would be added to the position labeled below.

 
Here is a back view of board. The jumper would go across these pins, indicated by a red line below:
 

New versions of the transfer switch may have a different board installed where a wire jumper can be added to a header.  In this case, the board is labeled as transfer switch delay.

Products covered in this article: GP-TS, GP-TS-30, GP-TS-50