List of Error Codes

Below are two tables that identify inverter error codes, and how to remedy them.

Remote Error Codes
PTOC (Over current protection)	Pulling to much current from inverter	Turn off loads, unplug from shore power, power cycle the inverter. Turn inverter back on and re-apply shore power
OTP (Over Temperature Protection)	Inverter or batteries are to hot	Check battery connections. Is battery to hot? Remove temp sensor
UTP (under temperature Protection)	Inverter or batteries are to cold	Warm batteries up in some way
UVP (Under voltage protection)	Battery voltage is below Low voltage disconnect point on the inverter	Recharge batteries above LVD set on inverter. Then turn inverter on and re-apply shore power
OOCP (Over current protection)	Second over current message	Turn off loads, unplug from shore power, power cycle the inverter. Turn inverter back on and re-apply shore power
OVP (Over voltage protection)	Battery volatge is to high	Unplug shore power power cycle the inverter. Run inverter without shore power to drop battery voltage. Check charge settings on all sources
Poff (NO ac power)	NO AC input power	Check breakers and AC getting to inverter
OLP Over Load protection	Loads to high for inverter output	Turn off loads, unplug from shore power, power cycle the inverter. Turn inverter back on and re-apply shore power. Turn loads on one by one eliminating load causing the issue